5 2 remove the lid from the water bath.
Laboratory water bath maintenance.
Afterwards thoroughly rinse the bath with water to make sure no soap is left behind.
Regularly adding fresh water will replenish the oxygen which helps maintain the protective chromium oxide layer on the stainless steel.
5 1 switch off the mains.
When the pan is removed for cleaning ensure the unit is unplugged.
Some top tips include the following.
Since almost all laboratory water bath has a digital interface to allow users to set a required temperature usually an indicator light turns on to indicate that the water bath is working.
5 3 wash the lid properly with purified water.
Cranson adds place your bath away from high traffic doorways and out of direct sunlight.
Keeping the samples in place with racks also helps.
5 2 ensure the water level in water bath.
Use only distilled water float the sample so the lids stay dry and keep the bath covered as much as possible.
Regularly adding fresh water will replenish the oxygen which helps maintain the protective chromium oxide layer on the stainless steel.
Clean the bath with soapy water and a cloth.
If you can find the user manual for the water bath you should check to see if there are any special cleaning instructions.
Avoid the use of chlorine containing cleaning supplies such as bleach and abrasive scrubbers because they will damage the bath and cause it to rust.
5 4 switch on the main power supply and instrument mains.
5 4 remove the water from the water bath and wash the water bath with purified water and mop with a clean dry cotton cloth.
This is especially important if the water is stationary or has been boiled.
Our microprocessor controlled thermo scientific water baths provide superior temperature uniformity for your specific applications and offer unique features such as a seamless stainless steel interior chamber and epoxy coated exterior which make them resistant to corrosion and chemical damage.
You should never use bleach in a misguided attempt to sterilize a water bath because it will corrode the stainless steel interior.
It is important to refill the bath with the right kind of water.
How scientists use a bath also matters.
Maintenance for water filled baths it is recommended that the bath is drained cleaned and re filled on a weekly basis to avoid build up of salts and contamination.
Wipe any debris off of the seal and avoid spilling water into the unit to avoid damage to electrical components.
Maintenance for water filled baths it is recommended that the bath is drained cleaned and re filled on a weekly basis to avoid build up of salts and contamination.
5 2 connect the power supply.
Clean the empty bath with soapy water and a cloth.
It should be sufficient to pour the heating element.